Propellerhead Reason - 4.0 Instrukcja Operacji Pobierz pdf (Strona 364)

THE EFFECT DEVICES

362

3. Now create a Spider CV and a second Matrix device and connect them as

in the picture below.

Note that the Note CV output from Matrix 1, and the Curve CV output of Matrix 2 should be

connected to the Spider. The merged output is connected to the Sequencer Control Note CV

input on the Subtractor.

4. On the Spider CV, turn the trimpot for the input connected to the Note CV

output fully to the right.

This setting will retain the correct pitch relationship for the notes played by the pat-

tern.

5. On the Spider CV, turn the trimpot for the input connected to the Curve CV

output to “32”.

This will produce a Curve CV output that corresponds to semitone steps.

6. Set the Curve type switch to “Bipolar” on the back of the second Matrix (Ma-

trix 2).

7. Flip the rack around so that the front panels are showing, and make the fol-

lowing settings for the “Matrix 2”:

• Set the number of steps to “1”.

• Set the Curve/Keys switch to “Curve”.

8. Adjust the Matrix 2 curve for step 1 (the only step used) so that it is in the

middle of the bipolar curve as the picture shows.

9. If you now activate Play from the transport, the pattern you programmed for

Matrix 1 is played back. By carefully adjusting the Matrix 2 Curve step 1 up or

down the Matrix 1 pattern is transposed in semitone steps.

By programming different values for the “pattern” played by Matrix 2 and saving

them in different pattern locations, you can use the Pattern selectors to transpose

the Matrix 1 pattern to different keys!

1 2 ... 359 360 361 362 363 364 365 366 367 368 369 ... 401 402

Brak uwag

Propellerhead Reason - 4.0 Instrukcja Operacji Strona 364