Propellerhead Reason - 4.0 Instrukcja Operacji Pobierz pdf (Strona 351)

THE EFFECT DEVICES

349

The EQ section

The equalizer in RV7000 affects the wet reverb sound only and is used for shaping

the character of the reverb. There are two EQ bands, one for low frequencies (shelv-

ing) and one full-range parametric EQ.

D To activate the EQ, click the EQ Enable button on the main panel so that

the indicator lights up.

D To make EQ settings, select “EQ” with the Edit Mode button to the left in

the remote programmer panel.

D In this mode, the remote programmer display shows a frequency curve,

indicating the settings you make with the EQ parameters.

The parameters are:

D Remember that you have a third EQ band at your disposal - the HI EQ pa-

rameter on the main panel.

The reason why this is on the main panel and not in the EQ section is simply that

it’s a setting you may want to adjust often, without having to open the remote pro-

grammer panel.

The Gate section

The Gate section allows you to create gated reverb effects with a lot of options and

possibilities. You can either trigger the gate from the source audio signal or via MIDI

or CV.

When triggering the gate from the source audio signal, it works like this:

• The gate “listens” to the source (dry) signal and opens whenever the signal

reaches a certain threshold level.

• The reverb sound is sent through the gate - when the gate is closed you won’t

hear the reverb.

• When the source signal level drops below the threshold level, the gate closes after

a time that depends on the Hold parameter and the level of the source signal (see

the parameter table).

D If you need the gate to be open for an exact duration (time), you should

trigger it via MIDI or CV.

In audio trigger mode, the actual gate time will vary depending on the source sig-

nal.

When triggering the gate via MIDI or CV, it works like this:

• The reverb sound is sent through the gate - when the gate is closed you won’t

hear the reverb.

• Whenever the gate receives any MIDI note (sent to the RV7000) or a gate signal

(connected to the Gate Trig CV input on the back of the RV7000), the gate opens

for the duration of the note or gate signal.

Note:

D To activate the Gate, click the Gate Enable button on the main panel so

that the indicator lights up.

D To make Gate settings, select “Gate” with the Edit Mode button to the

left in the remote programmer panel.

D In this mode, the remote programmer display shows two meters - one

showing the signal level (with an indication of the threshold level) and

one showing the status of the gate.

This is useful for checking what happens, how the gate triggers, etc.

Parameter

Description

Low Gain The amount of cut or boost of the low-shelving filter.

Low Freq The frequency below which the Low Gain cut or boost is applied.

Param Gain The amount of cut or boost for the parametric EQ.

Param Freq The center frequency of the parametric EQ, e.g. at which frequency

the level should be decreased or increased.

Param Q This governs the width of the affected area around the set center

frequency. The higher the value, the narrower the affected fre-

quency range.

1 2 ... 346 347 348 349 350 351 352 353 354 355 356 ... 401 402

Komentarze do niniejszej Instrukcji

Brak uwag

Propellerhead Reason - 4.0 Instrukcja Operacji Strona 351

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Propellerhead Reason - 4.0