Propellerhead Reason - 4.0 Instrukcja Operacji Pobierz pdf (Strona 163)

THE COMBINATOR

161

2. Click in the Target column for the Rotary or Button control you wish to assign

a parameter.

On the pop-up that appears, all the available parameters for the device are listed.

3. Select the parameter you wish to assign to the control.

The parameter is now assigned, and the name of the parameter is shown in the

Target column for the corresponding control.

4. If you wish the selected device to receive notes this option should be

checked.

5. If you move or press the assigned Rotary or Button it will now control the pa-

rameter you assigned to it.

6. You can specify a range for the parameter by clicking in the Min and Max col-

umns and moving the mouse up or down.

By default the maximum available range is set.

7. If you select another device in the Device list to the left, you can assign an-

other parameter to the same Rotary or Button control using the same basic

method.

This means that you can create multi-function controls that operate simultaneously

on several parameters. E.g. if you have two Subtractors and a Malström in a Combi

you could create a “master” filter cutoff knob, that controls this parameter for all

three devices.

Naming a control

When you make modulation routing assignments, you should give the associated con-

trol a descriptive name that reflects what it does, for example Vibrato On/Off or the

name of the parameter that it controls.

This is done by clicking the label on the Controller panel and typing in new name.

CV Connections

CV connections between devices in the Combi are saved with the Combi patches.

This is also true for CV connections between devices in Combi and the Combi itself -

e.g. if you have connected a Matrix in the Combi to one of the CV inputs on the back

of the Combi panel.

The following CV connectors can be found at the back of the Combinator:

Sequencer Control Inputs

The Sequencer Control CV and Gate inputs allow you to play the Combinator from

another CV/Gate device (typically a Matrix or a RPG-8). The signal to the CV input

controls the note pitch, while the signal to the Gate input delivers note on/off along

with velocity.

Modulation Inputs

In this section you will find standard CV Mod Wheel and Pitch Bend modulation in-

puts, as well as modulation inputs for the four Rotary controls.

! Parameter(s) that are assigned to a Rotary control can thus be modu-

lated by CV, which allows you to use CV control for almost any Reason

parameter!

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 401 402

Komentarze do niniejszej Instrukcji

Brak uwag

Propellerhead Reason - 4.0 Instrukcja Operacji Strona 163

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Propellerhead Reason - 4.0