Propellerhead Reason - 4.0 Instrukcja Operacji Pobierz pdf (Strona 179)

REDRUM

17 7

D To select a pattern in the current bank, click on the desired Pattern but-

ton (1-8).

If you like, you can assign computer key commands and/or MIDI messages to pat-

tern selection.

D To select a pattern in another bank, first click the desired Bank button (A,

B, C, D) and then click the Pattern button.

Nothing happens until you click the Pattern button.

D If you select a new pattern during playback, the change will take effect

on the next downbeat (according to the time signature set in the trans-

port panel).

If you automate pattern changes in the main sequencer, you can make them hap-

pen at any position - see page 87.

D Note that you cannot load or save patterns - they are only stored as part

of a song.

However, you can move patterns from one location to another (even between

songs) by using the Cut, Copy and Paste Pattern commands.

Pattern tutorial

If you are unfamiliar with step programming patterns, the basic principle is very intui-

tive and easy to learn. Proceed as follows:

1. Load a Redrum patch, if one isn’t already loaded.

2. Make sure an empty pattern is selected.

If you like, use the Clear Pattern command on the Edit menu or device context

menu to make sure.

3. Make sure that the “Enable Pattern Section” and the “Pattern” buttons are ac-

tivated (lit).

4. Press the “Run” button.

There will be no sound, as no pattern steps have been recorded yet. But as you

can see, the LEDs over the Step button light up consecutively, moving from left to

right, and then starts over. Each Step button represents one “step” in the Pattern.

5. Select a Redrum channel, by clicking the “Select” button at the bottom of the

channel.

The button lights up, indicating that this channel and the drum sound it contains is

selected.

6. While in Run mode, press Step button 1, so that it lights up.

The selected sound will now play every time Step 1 is “passed over”.

7. Clicking other Step buttons so they light up will play back the selected sound

as the sequencer passes those steps.

Clicking on a selected (lit) step button a second time removes the sound from that

step and the button goes dark again. You can click and drag to add or remove

steps quickly.

8. Select another Redrum channel to program steps for that sound.

Selecting a new sound or channel also removes the visual indications (static lit

buttons) of step entries for the previously selected sound. The step buttons always

show step entries for the currently selected sound.

9. Continue switching between sounds, and programming steps to build your

pattern.

Note that you can erase or add step entries even if Run mode isn’t activated.

Setting Pattern Length

You may want to make settings for Pattern length, i.e the number of steps the pattern

should play before repeating:

D Use the “Steps” spin controls to set the number of steps you wish the

pattern to play.

The range is 1 to 64. You can always extend the number of steps at a later stage,

as this will merely add empty steps at the end of the original pattern. You could

also make it shorter, but that would (obviously) mean that the steps “outside” the

new length won’t be heard. These steps aren’t erased though; if you raise the

Steps value again, the steps will be played back again.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 401 402

Komentarze do niniejszej Instrukcji

Brak uwag

Propellerhead Reason - 4.0 Instrukcja Operacji Strona 179

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Propellerhead Reason - 4.0