Propellerhead Reason - 4.0 Instrukcja Operacji Pobierz pdf (Strona 361)

THE EFFECT DEVICES

359

PEQ-2 Two Band Parametric

While there is a simple two-band shelving equalizer available for each channel in the

mixer, the PEQ-2 gives you much more precise control over the tone color. The device

consists of two independent, fully parametric equalizers and is most often used as an

insert effect, in mono or stereo.

About the two EQ modules

The two independent EQs are labeled “A” and “B”.

D EQ A is always active (provided that the effect device is in “On” mode

and that you have set the Gain to a value other than 0).

D To activate EQ B, click the button next to the EQ B parameters, so that

the LED lights up.

If you only use one EQ, it’s a good idea to turn EQ B off, to conserve computer

power.

Parameters

For both EQs (A and B), the following parameters are available:

About the graphic display

The graphic display to the left in the device panel shows the frequency response

curve as set by the EQ parameters. This gives a visual feedback and helps you tailor

the EQ settings.

CV Inputs

The following CV inputs are available on the back panel of the device:

D Freq 1 CV.

Allows you to control the frequency of EQ A from another device, creating subtle

or dramatic EQ sweeps depending on the Q and Gain settings.

D Freq 2 CV.

Allows you to control the frequency of EQ B in the same way.

Parameter

Description

Frequency This determines the center frequency of the EQ, e.g. at which fre-

quency the level should be decreased or increased. The range is

31 Hz to 16 kHz.

Q This governs the width of the affected area around the set center

frequency. The higher the value, the narrower the affected fre-

quency range.

Gain Specifies how much the level of the selected frequency range

should be boosted (positive values) or lowered (negative values).

The gain range is ±18 dB.

1 2 ... 356 357 358 359 360 361 362 363 364 365 366 ... 401 402

Brak uwag

Propellerhead Reason - 4.0 Instrukcja Operacji Strona 361