Propellerhead Reason - 4.0 Instrukcja Operacji Pobierz pdf (Strona 29)

SOUNDS, DEVICES AND PATCHES

Routing an Insert Effect between the Hardware Interface and

another device

D If you select the Hardware Interface and then create an effect, the effect

will be connected as an insert effect between the Hardware Interface and

whatever device was connected to the Hardware Interface inputs (nor-

mally the outputs of a a Mixer device).

This is the intended way to connect the MClass Mastering Suite Combi, at the

very end of the signal chain.

Auto-routing Devices after they have been Created

Here follows some additional rules about auto-routing devices that are already in the

rack:

D To reroute a device already in the rack, you can select it and use Discon-

nect Device and Auto-route Device, both on the Edit menu.

D If you delete a device connected between two devices, the connection

between the two remaining devices is automatically preserved.

A typical example would be if you have an effect device, connected as an insert ef-

fect between a synth and a mixer. If you delete the effect, the synth will be routed

directly to the mixer.

D When you move a device, connections are not affected.

If you instead would like the program to re-route the device according to its new

location in the rack, hold down [Shift] when you move it.

D When you duplicate devices (by dragging) or use copy and paste, the de-

vices are not auto-routed at all.

If you would like them to be automatically routed, hold down [Shift] when you per-

form the operation.

Manual Routing

To connect devices manually, you need to flip the rack around to see the back. This is

done by pressing [Tab] or selecting “Toggle Rack Front/Rear” from the Options

menu.

On the back of each device you will find connectors of two different types: audio and

CV (Control Voltage, used for controlling parameters - see “Using CV and Gate”). Au-

dio inputs and outputs are shown as large “quarter inch” jacks, while CV input and

output jacks are smaller. For now, we stick to audio connections.

! When the back is shown, you can still navigate in the rack by scrolling, by

using the computer keyboard, etc.

There are two ways to route audio from one device to another: by connecting “virtual

patch cables” between inputs and outputs, and by selecting connections from a pop-

up menu:

Audio connectors

CV connectors

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 401 402

Brak uwag

Propellerhead Reason - 4.0 Instrukcja Operacji Strona 29