Propellerhead Reason - 1.0.1 Przewodnik Szybki Start Pobierz pdf (Strona 47)

MANAGING THE RACK

A Quick Note on Routing

! This section only describes the basics in routing. For detailed de-

scriptions of routing procedures and possibilities, see the elec-

tronic documentation.

Reason allows for extremely flexible routing of audio and control signals be-

tween the devices in the rack. Basically, routing can be done automatically or

manually:

Automatic Routing

Auto-routing means that Reason makes all basic audio connections for a de-

vice, in one go. As mentioned on the previous pages, auto-routing is auto-

matically performed when you create a new device, and when you move,

duplicate or paste devices with [Shift] pressed.

✪ If applicable, auto-routing is automatically done in stereo.

Creating Mixers

➜ The first created mixer device will be routed to the Stereo inputs on

the Hardware Device.

If you create more mixers, they will be connected in series using the mix-

ers’ Chaining connections (see the electronic documentation).

Routing a device to the Mixer

➜ When you create an instrument device (synth, sampler, drum ma-

chine or loop player) it is automatically routed to the first available

mixer channel.

This makes it immediately available for use.

Routing a Send Effect to the Mixer

➜ When you have a mixer selected and create an effect device, it will

be connected as a send effect (to the first free Aux Send/Return).

Examples of effects that lend themselves well for use as send effects are

reverb, delay and chorus.

Routing an Effect Directly to a Device (Insert)

➜ When you have an instrument device selected and create an effect,

that effect will be connected as an insert effect. That is, the signal

from the device will pass through that effect and to the mixer.

Examples of effects that work well as inserts are distortion, compression

and phaser.

Auto-routing Devices after they have been Created

Here follows some additional rules about auto-routing devices that are al-

ready in the rack:

➜ To reroute a device already in the rack, you can select it and use

Disconnect Device and Auto-route Device, both on the Edit menu.

➜ If you delete a device connected between two devices, the connec-

tion between the two remaining devices is automatically preserved.

A typical example would be if you have an effect device, connected as an

insert effect between a synth and a mixer. If you delete the effect, the

synth will be routed directly to the mixer.

➜ When you move a device, connections are not affected.

If you instead would like the program to re-route the device according to

its new location in the rack, hold down [Shift] when you move it.

➜ When you duplicate devices (by dragging) or use copy and paste,

the devices are not auto-routed at all.

If you would like them to be automatically routed, hold down [Shift] when

you perform the operation.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 92 93

Komentarze do niniejszej Instrukcji

Brak uwag

Propellerhead Reason - 1.0.1 Przewodnik Szybki Start Strona 47

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie do edycji audio Propellerhead Reason - 1.0.1